Posts Tagged ‘Into

No engine mods, just the reset of the tank, straight pipes, a chopped rear fender, springer seat, forward controls, front forks and whatever mods to the fame need to be done. From a labor and parts stand point, how much could I expect to pay?
I can do some of the mods myself. Like install the [...]

My bf has a BMW 5 series that he LUUUVS. its already (nicely) tinted, already has rims, sunroof cd n all that. What is something that I can maybe surprise him with such as getting something installed that might be hot or he might like? For instance, I got him remote start for [...]

I have a front clip to ro a classic truck and would like to be able to hang it on the wall in my basement and wire the headlights to come on with a standard wall switch. I have no idea where to start. Any help would be much appreciated.

Hey, I just bought a 99 Kia Sephia and the transmission shifts really hard into second gear. Sometimes it’s verrrry noticeable and loud and other times not so much. It doesn’t do this when slowing down, only accelerating. Also, it doesn’t jerk in another gears. I know my motor mount needs to be replaced and [...]

All other gears work. Replaced relay, did not help. What should I check next?

I don’t know whether the bumper repair would be covered under Comprehensive or Collision. Would the boat trailer sliding forward on its own be considered vehicle hitting another vehicle (collision) or act of nature (comprehensive). The truck was parked & locked when this happend. The boat trailer was also unhitched, parked, and wheel [...]

Its a BOMZ intake for a 1992 Nissan Maxima SOHC V6. THe old intake led to the air filter which was bolted to the wheel well but the after market intake that leads to the filter has nothing to secure it down, what can i do, is it ok to have it just sitting there?

I know from bad experiences that carbureted bikes MUST have fuel stabilizer added to keep varnish from building up inside the carburetor. Costs about $350 to have the shop remove, clean and replace carbs. Not to mention lost riding time in the spring while the bike is in the shop.

Is it possible?

oil filter before installing it, as I have always thought was the thing to do. He just put the filter on, added the oil and started the engine. Did he do any harm? The truck holds 12 quarts.

I thought that the car battery was DC power but on my laptop screen there is a small AC charging icon does the adapter convert the DC power of car battery to AC to charge laptop?

I am getting an ipod classic… i just didn’t know thanks

Something about changing it to signals in the air, and to tune your radio to 88.1 or something so you can pick up the music…
What are they called, and where could you pick one up?

i want to hook up my 3 emergency lights i have cause of being a volunteer EMS provider. i want to plug all 3 into my cigg lighter outlet, can it handle it? i have a adapter that plugs into it, and allows you to plug in 3 things.
will this work? or will i blow [...]

I recently bought a new intake for my 99 mazda millenia s, but I don’t know how to put the temp sensor in. does it just snap in or something? thanks

I want to leave my GPS and radar detector plugged into my car cigarette power adaptor splitter. If I make sure that the devices are turned off and left plugged in, will it put a drain on the car’s battery?

For example… I drive pretty much a different vehicle every day, Sometimes they aren’t in the best condition. If, by chance, the cigarette lighter was faulty could it ruin my MP3 player which is being powered by it?

I have seen this electric car heater that says it will plug into my car cigarette lighter socket, it is 12V , im not sure if my Rover 400 1998, will be able to accept this, do most cars have 12v adapter socket, and should i buy it.

i been searching for cold air intakes to put in my RX-7 FC. but its too hard to find. i dont even know if its possible. please tell me if it is possible and maybe send me a link to get one. thanks.

For my project in auto class we are trying to get a 1992 nissan truck engine into a john deere ride on lawn mower. Everything is free. So is this possible, if it can be done how do we go about finding a driveshaft to connect the engine to the wheels?


About this site

In the 9th Nov, 2009 � RSPAuto make over this site to be place where you can make a question where or how you should buy auto parts or parts replacement for your cars or motorcycles

Premium Advertiser


  • VitalSkateFilms: i have a 1984 chevy g20 and it does exactly what you describe in this vid, it takes a lot of foot pr [...]
  • briansmobile1: There is strong evidence that you need a new brake booster. Double check the brake pad installation [...]
  • VitalSkateFilms: ok thanks, i replaced the brake pads about 3 months ago, and it was doing it before i replaced them [...]
  • destindave100: Any idea if this procedure will work on a 97 Thunderbird??? After removing everything else it looks [...]
  • briansmobile1: @destindave100 It will "work" it's likely that you can do it w. out pulling the wiper stuff. Try th [...]
eXTReMe Tracker