In: Mitsubishi
28 Feb 2010FIRST DECENT ANSWER GETS BEST ANSWER!!!!!!!!!
its the front passenger wheel bearing.
The thermostat on that is under the radiator cap which is on the engine. Pull the cap off and the thermostat is right there, pull it out and put another one in, top off coolant and bleed the system.
In: Mitsubishi
26 Feb 2010Under the small bell housing where the upper radiator hose connects to the top of the engine. Make sure you install the new thermostat the same way the old one was installed, since they sometimes can be installed backwards.
Short of doing a lot of rewiring, you can add a toggle switch, but you are still talking about a lot of wiring.
In: Toyota
24 Feb 2010The Toyota dealer wants $120.00 to change the cigarette lighter unit which is bad and blows fuses. A new external plug in lighter still blows fuses. I don’t have that kind of money for a lighter socket!! I’d like to buy a unit at an Auto store..but don’t know how to access the unit in [...]
line leaks only when car runs
can be hard to reach on some you have to press off the pulley thats on the pump just to get to the bolts. you will need a pulley puller for this you can rent one at a parts store. labor guide calls for 3.1 hrs so if you have never done one count on [...]
In: GMC
22 Feb 2010I changed my cousins oil on his 2003 gmc sierra 1500 4.3L. i put in 5w30 mobil 1 synthetic oil and an AC Delco oil filter. the next day he called and said his change oil light is on but it doesnt stay on constantly like i thought most gm vehicles do he says it [...]
In: GMC
22 Feb 2010Ive changed the oil and the filter but the light stays on. I have my car in the Balkans and the mechanic cannot turn the light off. Do I have any way of shutting this light off myself?
In: GMC
22 Feb 2010its a short bed extented cab, 4 wheel drive 1500
Maybe about 10 pints.
In: GMC
22 Feb 2010So…i took and oil wrench and it broke in half along with the can being crished and ripped off the block. Now all i have left is the base of the old oil filter and i have no clue how to get it off now. All that is left of the old oil filter is [...]
Some kind of sensor is attached to it and I am not sure how to take it off and remove the fuel filter. The filter itself is bigger than a oil filter.
GMC 3500 with the 6.6 Turbo Diesel
In: GMC
22 Feb 2010fitted and is the filter easy to get-to and to remove ect?And does the oil drain out of the filter with the engine oil too?
In: GMC
22 Feb 2010How often should we change the oil filter on a 2001 GMC Jimmy? I don’t believe you change the filter EVERY time you change the oil, and we’re using Castrol Syntec …the really expensive good synthetic stuff.
Thanks!
you have to remove the dash the the heater box and disassemble it to get to the heater core,its takes me about 5-6 hours to do one,usually for a beginner its about a 7-8 hour job by the time you get it all put back together and working again, it helps if you have good [...]
In: Nissan
21 Feb 2010ok heres what i got an 05 nissan 350z enthusiast. i want to buy a single greddy ti-c exhaust not the dual. i really want to change the WHOLE exhaust system. Now here is my question. if i buy that exhaust what other parts would i need to buy to basically [...]
In: Dodge
21 Feb 2010i have changed a few of those and the best i can do on one with no interruptions is about 6-8 hours to do the complete job,that’s counting pulling it in the shop and backing it out when im done,but like i said with no interruptions and that’s hard to do these days,id allow a [...]
In the 9th Nov, 2009 � RSPAuto make over this site to be place where you can make a question where or how you should buy auto parts or parts replacement for your cars or motorcycles