Thursday, November 19th, 2009
If you have not taken the brakes apart yet, do one side at a time and use the opposite side as a diagram. If you have already stripped everything then yes, go dump the 15 bucks in a service manual, they come in handy.
...
Posted in Ford | 2 Comments »
Saturday, May 30th, 2009
I have to replace the front wheel hub assembly on my 1997 cavalier about every 10,000 miles. I am wondering what the underlying problem is that would make this assembly keep going bad.
...
Posted in Cars | 3 Comments »
Tuesday, October 6th, 2009
Can I reuse the front wheel bearing on a 2000 Honda Accord after I pulled the wheel hub and a piece of the bearing is still pressed/attached to the wheel hub? The ball bearings look fine. I was told I can pressed the wheel hub back into the hub assembly by tightening the axle ...
Posted in Honda | 2 Comments »
Saturday, May 30th, 2009
Yes… “Assembly” means various parts together. If it’s just the hub, then no… but if they say assembly… then yes.
- Good Luck!
...
Posted in Cars | 2 Comments »
Saturday, May 30th, 2009
on a ‘96 olds cutlass ciera front wheel drive. how? and will simple manual ratchets be sufficient? i dont have an air ratchet.please help???
...
Posted in Cars | 1 Comment »
Friday, June 12th, 2009
I can find rear wheel bearing assemblies, but can’t find a front wheel bearing assembly for an 03 honda civic anywhere! (There are ones for 04-05). Do they even make these or am I going to have to use a press? Anyone know where I can find one?
...
Posted in Honda | 8 Comments »
Saturday, May 30th, 2009
One of the wheel lugbolt was screwed up so now the wheel is hold by four lugbolts. Need to change the Wheel Hub Assembly. When I took off the caliper found the problem: how to take off the holding bolts between axle and wheel hub? the bolts shadowed by the axle wrapper.
Who has the experience ...
Posted in Cars | 2 Comments »
Friday, January 22nd, 2010
Problem with conversion on my car, limited underbody support for driveshaft, and rear assembly suspension support. No solid suspension for rear wheels. Just a few stabilization bars and the strut stuck up in the tower near the passengers head.
Looking to change that. Shorter strut, and alot of welding.
1994 Nissan Maxima is the car.
Anyone have any ...
Posted in Nissan | 5 Comments »
Saturday, May 30th, 2009
How do I check the wheel Barrings (hub assembly) in a 2000 Hyundai Tiburon?
How do I know which one is bad. I get a loud humming from what sounds like the driver side back. but I would like to know if there is a way to tell if the others are bad or going bad ...
Posted in Cars | 3 Comments »
Saturday, May 30th, 2009
http://www.autozone.com/az/cds/en_us/090… Hope this info helps.Best of luck.
...
Posted in Cars | 3 Comments »
